1. 安装网卡

 

机器太新，以至于现有的Linux版本无法认出，比如机器找不到网卡，这时候怎么办呢？

 

别急，首先你需要知道网卡是什么型号的，以本实验室新购入的电脑为例，它的网卡是集成的，型号是Realtek RTL8168/8111 PCI-E Gigabit Ethernet NIC。然后我们到Realtek的官方网站去下载相应的Linux驱动程序r8168-8.005.00.tar.bz2，按照说明安装。

 

Unpack the tarball :

# tar vjxf r8168-8.aaa.bb.tar.bz2

Change to the directory:

# cd r8168-8.aaa.bb

If you are running the target kernel, then you should be able to do :

# make clean modules (as root or with sudo)

# make install

# /sbin/depmod -a

# /sbin/insmod ./src/r8168.ko (or r8168.o in linux kernel 2.4.x)

 

You can check whether the driver is loaded by using following commands.

 

# /sbin/lsmod | grep r8168(看看有没有加载网卡驱动)

# /sbin/ifconfig –a(看看有没有相关网卡被启动的信息)

 

If there is a device name, ethX, shown on the monitor, the linux

 

driver is loaded. Then, you can use the following command to activate

the ethX.

 

# ifconfig ethX up

,where X=0,1,2,...

 

这里也可以通过系统→管理→网络来设置IP地址等，最后激活。

 

1. Set manually

 

a. Set the IP address of your machine.

 

# ifconfig ethX "the IP address of your machine"

 

b. Set the IP address of DNS.

 

Insert the following configuration in /etc/resolv.conf.

nameserver "the IP address of DNS"

 

c. Set the IP address of gateway.

 

# route add default gw "the IP address of gateway"

 

2. Set by doing configurations in /etc/sysconfig/network-scripts

 

/ifcfg-ethX for Redhat and Fedora, or /etc/sysconfig/network

/ifcfg-ethX for SuSE. There are two examples to set network

configurations.

 

a. Fix IP address:

 

DEVICE=eth0

BOOTPROTO=static

ONBOOT=yes

TYPE=ethernet

NETMASK=255.255.255.0

IPADDR=192.168.1.1

GATEWAY=192.168.1.254

BROADCAST=192.168.1.255

 

2. 修改：＃vi /etc/hosts，在该文本中，增加两行：

 

127.0.0.1 localhost.localdomain localhost

192.168.4.101 node3（根据机器本身情况设置）

 

修改：vi /etc/hosts.equiv，增加一行：(如果没有该文本，可建立一个)

 

node3

 

3. 启动ssh服务

 

大部分的Linux版本应该都会自带该程序

 

＃ssh-keygen

＃cd .ssh

＃cp id_rsa.pub authorized_keys

＃ssh node3（如果成功，会显示上次登陆的时间， node3是主机名）

 

附加信息：

ifup eth0看看能否启动eth0

lsmod看看有没有加载网卡驱动

dmesg看看有没有网卡启动时的错误信息